Friday, November 5, 2010

Getting started

We started by mounting some of the larger parts to the chassis and dry fitting some of the components.





Not too far in we realized that the transformer covers would not actually fit over the output transformers.. I mean, no matter what ... they are about 1/4" too big!

I contacted the company and they replied something along the lines of...

"Yes, they are too big" and "You need to make them smaller to fit"

After asking for clarity, they replied once again with

"Reduce side covers carefully"

At this point, I kind of gave up on translating the directions.

I found a way to take the transformer apart and there are 2 metal covers that go over the coils.

Once they were removed, the cover had more than enough clearance.




We then mounted the side panels and started to translate the schematic!

No comments:

Post a Comment